Download:
pdf |
pdfU.S. Department of Energy
Energy Information Administration
Form NWPA-830G (Revised 03/12)
ANNEX A TO APPENDIX G
Standard Remittance Advice for Payment of Fees
OMB No. 1901-0260
(Expires
)
Annex A Instructions
0. General Information
0.1 Purpose: To report the calculation of fees due the
Department of Energy's Nuclear Waste Fund.
0.2 Please read all instructions before completing this form.
0.3 Complete a separate Annex A for each nuclear station. For
a nuclear station that has different ownership arrangements for more
than one reactor, a separate Annex A will be required for each reactor.
0.4 Submit Annex A Quarterly with Appendix G.
0.5 Where to submit:
U.S. Department of Energy
Energy Finance and Accounting Service Center, CF-11
19901 Germantown Road
Germantown. MD 20874-1290
Note: Computer-generated Remittance Advice forms are acceptable in
lieu of the three-part form. A signed Appendix G form must accompany
the Remittance Advice.
SECTION 1. Identification Information: (Self Explanatory)
Note: Enter form revision number, if applicable, in Item 1.53.
SECTION 2. Net Electricity Generated Calculation:
2.1 Unit ID Code: Enter the Reactor Unit Identification (ID) Code as
assigned by DOE, for each reactor in the station.
2.2 Gross Thermal Energy Generated (MWh): Utility shall report the
thermal output of the nuclear steam supply system during the gross
hours of the reporting period.
2.3 Gross Electricity Generated (MWh): Utility shall report this amount
for each unit in the appropriate column, and the total in the column
labeled "Station Total". This amount is measured at the output terminals
of the generator during the reporting period.
2.4a Nuclear Station Use while At Least One Nuclear Unit is in Service
(MWh): Utility shall report this amount for each unit in the appropriate
column, and the total in the column labeled "Station Total". The utility is
to report consumption of electricity by the nuclear portion of the station
during days in which at least one of the station's nuclear units was online and producing electricity. A utility unable to meter an individual unit
shall report the estimated unit use, and shall explain in Item 2.7 how the
unit data were estimated. Note:
A. During days in which nuclear station use exceeds nuclear
station generation, the utility shall treat all resulting negative values as
zero for fee calculation purposes.
B. A utility that has multiple nuclear units at one station:
* when at least 1 nuclear unit is operating and when generation
from that unit exceeds the nuclear station's use, the utility may assume
that the operating unit is supplying electricity for nuclear station use
whether or not the electricity for nuclear station use whether or not the
electricity has been metered separately or the units terminate to a
common electrical busbar; and
* shall report under Item 2.5 any electricity use by the nuclear
portion of the station during the days in which all nuclear units at the
station were out of service simultaneously.
C. A utility that has a metered transmission line connecting an offstation nuclear reactor with another nuclear station may treat the offstation plant as part of this station for fee calculation purposes if it is not
double counted.
D. Utility may deduct small quantities of unmetered non-nuclear
electricity generation included in "Gross Electricity Generated," provided
that it Is Identified and explained in Item 2.7.
E. A utility may deduct nuclear electricity generation which is not sold
and does not pass the busbar, provided they identify and explain the
deduction in Item 2.7 and that the deduction is not double counted.
2.4b Pumped-Storage Hydro Offset (MWh): Enter the amount of
electricity lost at hydroelectric pumped-storage generating stations
during the reporting period. Complete this item only if the DOE has
approved a methodology for calculating such offsets.
2.5 Nuclear Station Use While All Nuclear Units Are Out Of Service
(MWh): Utility shall report this amount for each unit in the appropriate
column, and the total in the "Station Total" column. In this row, the
utility shall report the consumption of electricity by the nuclear portion
of the station during days in which total nuclear unit use exceeds nuclear
generation (e.g., a day in which all nuclear units at the station were out
of service at once). Note: A utility unable to meter individual unit use will
report estimated unit use, and shall explain in Item 2.7 how the unit data
were estimated.
2.6 Net Electricity Generated (MWh): The utility shall report this amount
for each unit in the appropriate column, and the total in the "Station
Total" column. This amount is the result of subtracting Items 2.4a and
2.4b from Item 2.3.
2.7 Footnote (if any): Utilities that are unable to meter individual unit
use shall explain here how the unit data were estimated.
SECTION 3. Total Energy Adjustment Factor Calculation:
The reporting utility shall obtain necessary data from all owners to
calculate the Total Energy Adjustment Factor (TEAF) and maintain
consistent, accurate, and complete records to support these
submissions. All calculations and data shown in Item 3.3 must maintain
5-decimal places (rounding from 6). Item 3.4, TEAF, is to be rounded to 4
decimal places. If there are more than 12 owners, use a continuation
sheet. For a nuclear station with more than one reactor and different
ownerships for each reactor, a separate Annex A will be required for
each reactor.
3.1 Data Source: Each utility shall designate the source of data being
reported (i.e., Energy Information Administration (EIA) Form EIA-861 or
Federal Energy Regulatory Commission (FERC) Form No. 1) for each
nuclear station owner. Note: For data sources other than those
referenced above, supporting documentation is required (specify in
attachment).
3.2 Owner's Share method: For multiple nuclear station owners, utilities
shall indicate the method of allocating the owner's shares; Contractual,
Prorata Share of Electricity; and Fixed Entitlement Share.
3.3 Weighted Energy Adjustment Factor Calculation:
Name of Nuclear Station Owner(s): Provide the name(s) in Items 1
through 12, of 3.3. If more than 12 names, use a continuation sheet.
Data Source: Indicate the data source enumerated in Item 3.1.
Adjustment for Sales to ultimate Consumer (ASC): The product of
Fraction of Sales to ultimate Consumer (FSC) and the Sales to ultimate
Consumer Adjustment Factor (SCAF).
Fraction of Sales to ultimate Consumer (FSC): Determined by dividing
the owner's previous year's annual sales to the ultimate consumer by the
sum of the owner's previous year's annual sales to the ultimate
consumer plus the owner's previous year's annual sales for resale. These
figures can be found on the Form EIA-861 or the FERC Form No. 1.
Sales to ultimate Consumer Adjustment Factor (SCAF): Equal to one
minus the quotient of all electricity lost or otherwise not sold for each
owner, divided by the total electricity available for disposition to
ultimate consumers. The total electricity available is the reporting year
total of all of an owner's electricity supply which is available for
disposition, expressed in kilowatt hours. Electricity lost or otherwise not
sold includes: (a) energy furnished without charge; (b) energy used by
the company; (c) transmission losses; (d) distribution losses; and (e)
other accounted losses as reported on the Form EIA-861 or the FERC
Form No. 1.
Adjustment for Sales for Resale (ASR): The product of Fraction of
Sales for Resale (FSR) and National average Adjustment Factor (NAF).
Fraction of Sales for Resale (FSR): Determined by dividing the owner's
previous year's annual sales for resale by the sum of the owner's
previous year's annual sales to the ultimate consumer plus the owner's
previous year's annual sales for resale. These figures can be found on the
Form EIA-861 or the FERC Form No. 1.
National average Adjustment Factor (NAF): The quotient of the
national total of electricity sold divided by the national total of electricity
available for disposition.
Owner's Energy Adjustment Factor (OEAF): The Owner's fraction of
metered electricity.
Weighted Energy Adjustment Factor (WEAF): The product of an
Owner's Energy Adjustment Factor (OEAF) times the Owner's Share (OS).
3.4 Total Energy Adjustment Factor (TEAF): The sum of individual
owner's Weighted Energy Adjustment Factors (WEAF).
SECTION 4. Fee Calculation for Electricity Generated and Sold:
4.1 Total Energy Adjustment Factor (TEAF): Enter the value from Item
3.4 as appropriate.
4.2 Electricity Generated and Sold: Multiply the values in Item 4.1 by
the "Unit" values in Item 2.6. Sum these values and enter in "Station
Total".
4.3 Current fee Due (Whole Dollars): Multiply the values in Item 4.2 by
one (1) dollar/megawatt hour (or mill/kWh), which is the current fee.
Add this station fee to the current fee due for all other reactors operated
by the Purchaser, and then enter the sum (whole dollars) in Item 3.4 of
the Appendix G, Standard Remittance Advice for Payment of Fees.
File Type | application/pdf |
Author | USCX |
File Modified | 2012-03-06 |
File Created | 2012-03-06 |