Safety Defects-Examination, Correction, and Records
Revision of a currently approved collection
No
Regular
Approved without change
06/02/2017
03/30/2017
table that charts list comparision
Inventory as of this Action
Requested
Previously Approved
06/30/2020
36 Months From Approved
06/30/2017
3,470,695
0
10,368,771
768,728
0
1,145,141
154,300
0
0
Section 103(h) of the Federal Mine Safety and Health Act of 1977 (Mine Act), 30 U.S.C. § 813(h), authorizes MSHA to collect information necessary to carry out its duty in protecting the safety and health of miners.
Title 30 C.F.R. §§ 56.13015 and 57.13015 require compressed-air receivers and other unfired pressure vessels to be inspected by inspectors holding a valid National Board Commission and in accordance with the applicable chapters of the National Board Inspection Code, a Manual for Boiler and Pressure Vessels Inspectors, 1979. Safety defects found on compressed-air receivers and other unfired pressure vessels have caused injuries and fatalities in the mining industry.
Records of inspections must be kept in accordance with the requirements of the National Board Inspection Code and the records must be made available to the Secretary or an authorized representative.
Title 30 C.F.R. §§ 56.13030 and 57.13030 require that fired pressure vessels (boilers) must be equipped with water level gauges, pressure gauges, automatic pressure-relief valves, blowdown piping and other safety devices approved by the American Society of Mechanical Engineers (ASME) to protect against hazards from overpressure, flameouts, fuel interruptions and low water level.
These sections also require that records of inspection and repairs be retained by the mine operator in accordance with the requirements of the ASME Boiler and Pressure Vessel Code, 1977, and the National Board Inspection Code (progressive records - no limit on retention time) and shall be made available to the Secretary or an authorized representative.
Title 30 C.F.R. §§ 56.14100 and 57.14100 require operators to inspect equipment, machinery, and tools that are to be used during a shift for safety defects before the equipment is placed in operation.
Adjustments have been made to update respondent numbers, responses, and hours. A program change was made by adding a new provision 56/57.18002(d) due to the rule which added 8,572 hours. Changes are as follows.
Burden hours have decreased from 1,145,141 to 768,728 hours.
Responses have decreased from 10,368,771 to 3,470,695.
Costs have increased from $0 to $154,300.
Respondents decreased from 12,375 to 11,660.
On behalf of this Federal agency, I certify that the collection of information encompassed by this request complies with 5 CFR 1320.9 and the related provisions of 5 CFR 1320.8(b)(3).
The following is a summary of the topics, regarding the proposed collection of information, that the certification covers:
(i) Why the information is being collected;
(ii) Use of information;
(iii) Burden estimate;
(iv) Nature of response (voluntary, required for a benefit, or mandatory);
(v) Nature and extent of confidentiality; and
(vi) Need to display currently valid OMB control number;
If you are unable to certify compliance with any of these provisions, identify the item by leaving the box unchecked and explain the reason in the Supporting Statement.
1219-0089 Supporting Statement 1-23-2017 rule.doc
Chajet Mining_Coalition_Workplace_Examination_Post_Hearing_Comments.pdf
Birmingham transcript MNM exams hearing Aug 4.docx
Safety Defects; Examination, Correction and Records