5900-82 Emission Unit Description for Process Sources (EUD3)

EUD-3 3

OMB No. 2060-0336,

Approval Expires 05/31/2019

Federal Operating Permit Program (40 CFR Part 71)

EMISSION UNIT DESCRIPTION FOR PROCESS SOURCES (EUD-3)

A. General Information

Emissions unit ID ___________ Description __________________________________

SIC Code (4-digit) __________ SCC Code________

B. Emissions Unit Description

Primary use or equipment type _____________________________________________

Manufacturer __________________________ Model No. _______________________

Serial No. _____________________________ Installation date _____/_____/_____

Raw materials ____________________________________________________________

Finished products _________________________________________________________

Temporary source: ___No ___Yes

C. Activity or Production Rates

Activity or Production Rate	Amount/Hour	Amount/Year
Actual Rate
Maximum rate

D. Associated Air Pollution Control Equipment

Emissions unit ID ____________ Device Type___________________________________

Manufacturer _______________________ Model No______________________________

Serial No. ______________________________ Installation date _____/_____/_________

Control efficiency (%) _________.___ Capture efficiency (%) ________.___

Air pollutant(s) controlled ______________ Efficiency estimation method _______________

E. Ambient Impact Assessment

This information must be completed by temporary sources or when ambient impact assessment is an applicable requirement for this emissions unit (This is not common)).

Stack height (ft) __________._____ Inside stack diameter (ft) _________._____

Stack temp (F) __________._____ Design stack flow rate (ACFM) __________.____

Actual stack flow rate (ACFM) ____________.____ Velocity (ft/sec) ____________.____

INSTRUCTIONS FOR EUD-3

EMISSIONS UNIT DESCRIPTION FOR PROCESS SOURCES

This form is designed to describe emissions units for processes for which forms EUD-1 or EUD-2 are not appropriate. For example, sources such as rock crushers and asphalt batch plants. This form will help you to collect and organize technical information, including operational characteristics, applicable requirements, compliance terms, and emissions for each emissions unit.

Section A - The emissions unit ID should be consistent with the one used in section I of form GIS. Enter the four-digit SIC code for the unit, which may be different form that used for the facility as a whole. In addition, complete the Source Classification Code (SCC), if known or available, but this is not mandatory.

Section B - There may be other information that the permitting authority will need to know that is not specifically requested on the forms and that should be included on attachments. Such information would include information needed to adequately identify the emissions unit and to determine its applicable requirements.

Section C - The amount of raw materials that are processed and/or the number of activities performed are values that are typically multiplied by emissions factors to calculate PTE and actual emissions.

Section D - Identify and describe any associated air pollution control device. Attach copies of correspondence from the vendor documenting these values, if available, or indicate how these values were otherwise determined (e.g., AP-42).

Section E - Complete this section only if ambient impact assessment is an applicable requirement or the facility is a temporary source. This is not common.

EPA Form 5900-82