RUS Form 224, Waiver and Release of Lien

According to the Paperwork Reduction Act of 1995, an agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a valid OMB control
number. The valid OMB control number for this information collection is 0572-0107. The time required to complete this information collection is estimated to average 1 minute per response, including
the time for reviewing instructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information. Send comments regarding
this burden estimate or any other aspect of this collection of information including suggestions for reducing burden to: USDA-RUS, Attn.: Director, PDRA, 1400 Independence Ave., S.W., STOP, 1522,
Washington, DC 20250-1522; and to the Office of Information and Regulatory Affairs, Paperwork Reduction Project (1910-1800), Office of Management and Budget DC 20503.

U.S. Department of Agriculture
Rural Utilities Service

WAIVER AND RELEASE OF LIEN

WHEREAS the undersigned,
NAME OF MANUFACTURER, MATERIAL SUPPLIER OR SUBCONTRACTOR

has furnished to

the following:
NAME OF CONTRACTOR

for
KIND OF MATERIAL AND SERVICES FURNISHED

use in the construction of a project belonging to
NAME OF BORROWER

and designated the Rural Utilities Service as
RUS DESIGNATION

NOW, THEREFORE, the undersigned,
NAME OF MANUFACTURER, MATERIAL SUPPLIER, OR SUBCONTRACTOR

and other good and valuable
for and in consideration of $
consideration, the receipt whereof is hereby acknowledged, do(es) hereby waive and release any and all liens, or
right to or claim of lien, on the above described project and premises, under any law, common or statutory, on
account of labor or materials, or both, heretofore or hereafter furnished by the undersigned to or for the account of
for said project .

said
NAME OF CONTRACTOR

Given under my (our) hand(s) and seal(s) this

day of

,20

.

Name of Manufacturer, Material Supplier, or Subcontractor

By
President
This Waiver and Release of Lien must be signed with the full name of the Manufacturer, Material Supplier, or Subcontractor. If the Manufacturer,
Material Supplier, or Subcontractor is a partnership, this Waiver and Release of Lien must be signed in the partnership name by a partner. If the
Manufacturer, Material Supplier, or Subcontractor is a corporation, this Waiver and Release of Lien must be signed in the corporate name by a
duly authorized officer and the corporate seal affixed and attested by the Secretary of the Corporation.

Expires: 03/31/2015

RUS FORM 224 (Rev. 2-04)