Form FAA Form 9550 FAA Form 9550 FINAL PROJECT REPORT

INSTRUCTIONS FOR FINAL PROJECT REPORT

One copy of this report is due within 90 days after the expiration of the award. It should be submitted to the cognizant technical monitor
in the FAA award letter.

INSTRUCTIONS FOR PART I
These identifying data items should be the same as on the award documents.

INSTRUCTIONS FOR PART II
The summary (about 200 words) must be self-contained and intelligible to a scientifically literate reader. Without restating the project
title, it should begin with a topic sentence stating the project's major thesis. The summary should include, if pertinent to the project
being described, the following items:
-

The primary objectives and scope of the project. The techniques or approaches used

-

(only to the degree necessary for comprehension). The findings and implications

-

stated as concisely and informatively as possible.

FAA may disseminate the project report through the National Technical Information Service (NTIS) of the Department of Commerce.
Authors should also be aware that the summary may be used to answer inquiries by nonscientists as to the nature and significance of
the supported activity. Scientific jargon and abbreviations should be avoided.

INSTRUCTIONS FOR PART III
Items in Part III may, but need not, be submitted with this Final Project Report. Place a check mark in the appropriate block next to
each item to indicate the status of your submission.
a. Self-explanatory.
b. For publications (published and planned) include title, journal or other reference, date, and authors. Provide two copies of
any reprints as they become available.
c. Scientific Collaborators provide a list of co-investigators, research assistants and others associated with the
project. Include title or status, e.g. associate professor, graduate student, etc.
d. Briefly describe any inventions which resulted from the project and the status of pending patent applications, if any.
e. Provide a technical summary of the activities and results. The information supplied in proposals for further support, updated as
necessary, may be used to fulfill this requirement.
f. Include any additional material, either specifically required in the award instrument (e.g. special technical reports or products such as
films, books, studies) or which are considered to be useful to the Foundation.
PAPERWORK REDUCTION ACT
A federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply
with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a currently valid
OMB Control Number. The OMB Control Number for this information collection is 2120-0559. Public reporting for this collection of information is estimated
to be approximately 3 hours per response, including the time for reviewing instructions, searching existing data sources, gathering and maintaining the data
needed, completing and reviewing the collection of information. All responses to this collection of information are required to obtain or retain benefits by
Public Law 101-508. Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing
this burden to the FAA at: 800 Independence Ave. SW, Washington, DC 20591, Attn: Information Collection Clearance Officer, ASP-110.

FINAL PROJECT
REPORT

U.S. Department of Transportation
Federal Aviation Administration

Form Approved:
O.M.B. No. 2120-0559
8/31/2020

PART I - PROJECT IDENTIFICATION INFORMATION
1. Institution and Address

2. FAA Program

3. FAA Award Number

4. Award Period

5. Cumulative Award Amount

From

To

6. Project Title

PART II - SUMMARY OF COMPLETED PROJECT (For Public Use)

PART III - TECHNICAL INFORMATION (For Program Management Uses)
1.
ITEM (Check appropriate blocks)

NONE

ATTACHED

PREVIOUSLY
FURNISHED

TO BE FURNISHED
SEPARATELY TO PROGRAM
Check ( X )

Approx. Date

a. Abstracts of Theses
b. Publication Citations
c. Data on Scientific Collaborators
d. Information on Inventions
e. Technical Description of Project and Results
f. Other (specify)
2. Principal Investigator/Project Director Name (Typed)

FAA Form 9550-5 (03-03) Supersedes Previous Edition

3. Principal Investigator / Project Director
Signature

4. Date