DOE F 220.87 Dedicated-Purpose Pool Pumps

---

Overview

Certification
Input
Product Group Codes

---

Sheet 1: Certification

OMB Control Number: 1910-1400 (Expiration Date: September 30, 2024)

Version 5.1

DOE F 220.87

Dedicated Purpose Pool Pumps

Product Type:

Dedicated Purpose Pool Pumps

Status of This Certification Sheet

No Data

5.1

Overall Status of Template

No Data

Click here for instructions for completing this form

Each Importer and U.S. Manufacturer is legally required to certify the compliance of the products it imports, produces, assembles or manufactures. This party is the "Certifier" on this form. This certification may be submitted by the Importer or U.S. manufacturer or by a Third Party Representative. This party is the "Submitter" on this form.

Certifier - Party Legally Obligated to Certify Compliance

Submitter - Party Submitting This Report

The party responsible for certification is (select one only):

The party submitting this report is (select one only):

Please enter required data

Please enter required data

Certifier Contact Information

Third Party Representative Contact Information, if Applicable

Full Legal Name of Individual

Please enter required data

Full Legal Name of Individual

Please enter required data

Full Legal Name of Company

Please enter required data

Full Legal Name of Company

Please enter required data

Complete Company Mailing Address

Please enter required data

Complete Company Mailing Address

Please enter required data

Phone Number

Please enter required data

Phone Number

Please enter required data

Email Address

Please enter required data

Email Address

Please enter required data

Compliance Statement

Select one of the options for 'Submitter - Party Submitting This Report' above

Submitter Signature (Type your Full Legal Name)

Please enter required data

Date (MM/DD/YYYY)

Please enter required data

OMB Control Number: 1910-1400 (Expiration Date: September 30, 2024)

Paperwork Reduction Act Statement

OMB Burden Disclosure Statement

This data is being collected for manufacturers to certify compliance to DOE's energy conservation, water conservation, or design standards. The data you supply will be used by the Department to monitor compliance with the energy conservation, water conservation, and design standards and testing requirements for the consumer products and commercial and industrial equipment mandated by the Energy Policy and Conservation Act, as amended. Public reporting burden for this collection of information is estimated to average 35 hours per response, including the time for reviewing instructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information. Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing this burden, to Office of the Chief Information Officer, Records Management Division, IM-23, Paperwork Reduction Project (1910-1400), U.S. Department of Energy, 1000 Independence Ave SW, Washington, DC, 20585-1290; and to the Office of Management and Budget (OMB), OIRA, Paperwork Reduction Project (1910-1400), Washington, DC 20503. Notwithstanding any other provision of the law, no person is required to respond to, nor shall any person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a currently valid OMB control number. Submission of this data is mandatory.

---

Sheet 2: Input

Dedicated Purpose Pool Pumps	Dedicated Purpose Pool Pumps								Version 5.1		· Please enter your data in the columns shaded in gray below, using a separate line for each model. · Click on the column heading for instructions on how to complete cells in that column. · Cells highlighted in yellow indicate an "Error." "Error" means that information is missing or there is an issue with the entry. · If the "Status" for a row is "Error," you can see an explanation in the columns to the far right.
5.1
	Status of This Input Sheet		No Data	Overall Status of Template		No Data
	Certification Report			Click here for instructions for completing this form																																	The cells below provide an explanation for "Errors".						The cells below provide an explanation for "Errors".					The cells below provide an explanation for "Errors".					The cells below provide an explanation for "Errors".					The cells below provide an explanation for "Errors".					The cells below provide an explanation for "Errors".					The cells below provide an explanation for "Errors".
Line No.	Status	Manufacturer	Brand Name(s)	Basic Model Number	Individual Model Number Covered by Basic Model	Action	Product Group Code	Sample Size (Number of Units Tested)	Is the Certification for this Basic Model Based on a Waiver of DOE's Test Procedure Requirements?	Date of Test Procedure Waiver, if Applicable	Is the Certification based upon any Exception Relief from an Applicable Standard by DOE's Office of Hearing and Appeals?	Date of Exception Relief, if Applicable	Complete the Cells Below for Integral Cartridge-Filter and Sand-Filter Pool Pumps	Complete the Cells Below for Dedicated-Purpose Pool Pumps Subject to the Test Methods Prescribed in Section 431.464(b)								Complete the Cells Below for Dedicated-Purpose Pool Pumps Subject to the Test Methods Prescribed in Section 431.464(b)						Complete the Cells Below for Dedicated-Purpose Pool Pumps Subject to the Test Methods Prescribed in Section 431.464(b)								Manufacturer Status	Brand Name(s) Status	Basic Model Number Status	Individual Model Number Covered by Basic Model Status	Action Status	Product Group Code Status	Sample Size (Number of Units Tested) Status	Is the Certification for this Basic Model Based on a Waiver of DOE's Test Procedure Requirements? Status	Date of Test Procedure Waiver, if Applicable Status	Is the Certification based upon any Exception Relief from an Applicable Standard by DOE's Office of Hearing and Appeals? Status	Date of Exception Relief, if Applicable Status	Maximum Run-Time (in hours) of the Pool Pump Control with Which the Integral Cartridge-Filter or Sand-Filter Pump is Distributed in Commerce Status	Weighted Energy Factor (WEF) in kilogallons per kilowatt-hour (kgal/kWh) Status	Rated Hydraulic Horsepower in horsepower (hp) Status	Speed Configuration for Which the Pump is Being Rated (i.e., single-speed, two-speed, multi-speed, or variable-speed) Status	True Power Factor at High Load Point, as Specified in Table 1 of Appendix B or C to Subpart Y of Part 431, As Applicable Status	True Power Factor at Low Load Point, as Specified in Table 1 of Appendix B or C to Subpart Y of Part 431, As Applicable Status	Dedicated-Purpose Pool Pump Nominal Motor Horsepower in horsepower (hp) Status	Dedicated-Purpose Pool Pump Motor Total Horsepower in horsepower (hp) Status	Dedicated-Purpose Pool Pump Service Factor (dimensionless) Status	For Self-Priming Pool Filter Pumps and Non-Self-Priming Pool Filter Pumps, Maximum Head (in feet) Status	For Self-Priming Pool Filter Pumps and Non-Self-Priming Pool Filter Pumps, Is Freeze Protection Shipped Enabled or Disabled? Status	For Dedicated-Purpose Pool Pumps Distributed in Commerce with Freeze Protection Controls Enabled: The Default Dry-Bulb Air Temperature Setting (in degrees F) Status	For Dedicated-Purpose Pool Pumps Distributed in Commerce with Freeze Protection Controls Enabled: Default Run-Time Setting (in minutes) Status	For Dedicated-Purpose Pool Pumps Distributed in Commerce with Freeze Protection Controls Enabled: Default Motor Speed (in rpm) Status	For Dedicated-Purpose Pool Pumps Distributed in Commerce with Freeze Protection Controls Enabled: Is the Default Motor Speed More than 1/2 of the Maximum Available Speed? Status	For Self-Priming Pool Filter Pumps, was the Pump Certified with NSF/ANSI 50-2015 (incorporated by reference, see Section 429.4) as Self-Priming? Status	For Self-Priming Pool Filter Pumps that are not Certified with NSF/ANSI 50-2015 as Self-Priming: The Vertical Lift (in feet) Status	For Self-Priming Pool Filter Pumps that are not Certified with NSF/ANSI 50-2015 as Self-Priming: True Priming Time (in minutes) for the DPPP Model Status	Calculated Driver Power Input at High Load Point, in horsepower (hp), Optional Status	Calculated Driver Power Input at Low Load Point, in horsepower (hp), Optional if Applicable Status	Calculated Driver Flow Rate at High Load Point, in Gallons per Minute (gpm), Optional Status	Calculated Driver Flow Rate at Low Load Point, in Gallons per Minute (gpm), Optional if Applicable Status
													Maximum Run-Time (in hours) of the Pool Pump Control with Which the Integral Cartridge-Filter or Sand-Filter Pump is Distributed in Commerce	Weighted Energy Factor (WEF) in kilogallons per kilowatt-hour (kgal/kWh)	Rated Hydraulic Horsepower in horsepower (hp)	Speed Configuration for Which the Pump is Being Rated (i.e., single-speed, two-speed, multi-speed, or variable-speed)	True Power Factor at High Load Point, as Specified in Table 1 of Appendix B or C to Subpart Y of Part 431, As Applicable	True Power Factor at Low Load Point, as Specified in Table 1 of Appendix B or C to Subpart Y of Part 431, As Applicable	Dedicated-Purpose Pool Pump Nominal Motor Horsepower in horsepower (hp)	Dedicated-Purpose Pool Pump Motor Total Horsepower in horsepower (hp)	Dedicated-Purpose Pool Pump Service Factor (dimensionless)	For Self-Priming Pool Filter Pumps and Non-Self-Priming Pool Filter Pumps, Maximum Head (in feet)	Complete the Cells Below for All Dedicated-Purpose Pool Pumps Distributed in Commerce with Freeze Protection Controls					For Self-Priming Pool Filter Pumps, was the Pump Certified with NSF/ANSI 50-2015 (incorporated by reference, see Section 429.4) as Self-Priming?	For Self-Priming Pool Filter Pumps that are not Certified with NSF/ANSI 50-2015 as Self-Priming: The Vertical Lift (in feet)	For Self-Priming Pool Filter Pumps that are not Certified with NSF/ANSI 50-2015 as Self-Priming: True Priming Time (in minutes) for the DPPP Model	Calculated Driver Power Input at High Load Point, in horsepower (hp), Optional	Calculated Driver Power Input at Low Load Point, in horsepower (hp), Optional if Applicable	Calculated Driver Flow Rate at High Load Point, in Gallons per Minute (gpm), Optional	Calculated Driver Flow Rate at Low Load Point, in Gallons per Minute (gpm), Optional if Applicable
																							For Self-Priming Pool Filter Pumps and Non-Self-Priming Pool Filter Pumps, Is Freeze Protection Shipped Enabled or Disabled?	For Dedicated-Purpose Pool Pumps Distributed in Commerce with Freeze Protection Controls Enabled: The Default Dry-Bulb Air Temperature Setting (in degrees F)	For Dedicated-Purpose Pool Pumps Distributed in Commerce with Freeze Protection Controls Enabled: Default Run-Time Setting (in minutes)	For Dedicated-Purpose Pool Pumps Distributed in Commerce with Freeze Protection Controls Enabled: Default Motor Speed (in rpm)	For Dedicated-Purpose Pool Pumps Distributed in Commerce with Freeze Protection Controls Enabled: Is the Default Motor Speed More than 1/2 of the Maximum Available Speed?
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100

---

Sheet 3: Product Group Codes

The following is a description of each product group code:
Product Group Code	Equipment Family	Rated Hydraulic Horsepower Applicability	Motor Phase
1	Self-priming pool filter pumps	0.711 hp <= hhp < 2.5 hp	Single
2	Self-priming pool filter pumps	hhp < 0.711 hp	Single
3	Non-self-priming pool filter pumps	hhp < 2.5 hp	Any
4	Pressure cleaner booster pumps	Any	Any
5	Integral cartridge-filter pool pump	-	-
6	Integral sand-filter pool pump	-	-