The assumptions
used to calculate burden and cost for industry and the agency need
to be updated before resubmitting it for approval.
Inventory as of this Action
Requested
Previously Approved
09/30/2010
36 Months From Approved
09/30/2007
53
0
237
435
0
2,448
1,500
0
8,000
The respondents to the information
collection are owners or operators of facilities subject to the
stationary combustion turbine NESHAP. The information is requested
by the agency to determine compliance with the rule. The
information will then be used by enforcement agencies to verify
that sources subject to the standard are meeting the emission
reductions mandated by the Clean Air Act.
The decrease in burden from the
most recently approved ICR is due to a change in the regulation. On
August 18, 2004 (69 FR 51184), the EPA stayed the effectiveness of
this standard for gas fired turbines. As a result, only new oil
fired turbines located at major HAP sources are subject to emission
standards under Subpart YYYY at this time. We do not expect new
standards for the gas fired units under this standard to be
promulgated within the next three years. However, new gas fired
units are required to submit a one-time initial notification. The
change in the Capital/Startup vs. Operation and Maintenance
(O&M) Costs, as calculated in section 6(b)(iii), also decreased
as a result of the regulatory change on August 18, 2004.
On behalf of this Federal agency, I certify that
the collection of information encompassed by this request complies
with 5 CFR 1320.9 and the related provisions of 5 CFR
1320.8(b)(3).
The following is a summary of the topics, regarding
the proposed collection of information, that the certification
covers:
(i) Why the information is being collected;
(ii) Use of information;
(iii) Burden estimate;
(iv) Nature of response (voluntary, required for a
benefit, or mandatory);
(v) Nature and extent of confidentiality; and
(vi) Need to display currently valid OMB control
number;
If you are unable to certify compliance with any of
these provisions, identify the item by leaving the box unchecked
and explain the reason in the Supporting Statement.