Section 103(h) of the Federal Mine
Safety and Health Act of 1977 (Mine Act), 30 U.S.C. § 813(h),
authorizes MSHA to collect information necessary to carry out its
duty in protecting the safety and health of miners. Title 30 C.F.R.
§§ 56.13015 and 57.13015 require compressed-air receivers and other
unfired pressure vessels to be inspected by inspectors holding a
valid National Board Commission and in accordance with the
applicable chapters of the National Board Inspection Code, a Manual
for Boiler and Pressure Vessels Inspectors, 1979. Safety defects
found on compressed-air receivers and other unfired pressure
vessels have caused injuries and fatalities in the mining industry.
Records of inspections must be kept in accordance with the
requirements of the National Board Inspection Code and the records
must be made available to the Secretary or an authorized
representative. Title 30 C.F.R. §§ 56.13030 and 57.13030 require
that fired pressure vessels (boilers) must be equipped with water
level gauges, pressure gauges, automatic pressure-relief valves,
blowdown piping and other safety devices approved by the American
Society of Mechanical Engineers (ASME) to protect against hazards
from overpressure, flameouts, fuel interruptions and low water
level. These sections also require that records of inspection and
repairs be retained by the mine operator in accordance with the
requirements of the ASME Boiler and Pressure Vessel Code, 1977, and
the National Board Inspection Code (progressive records - no limit
on retention time) and shall be made available to the Secretary or
an authorized representative. Title 30 C.F.R. §§ 56.14100 and
57.14100 require operators to inspect equipment, machinery, and
tools that are to be used during a shift for safety defects before
the equipment is placed in operation.
On behalf of this Federal agency, I certify that
the collection of information encompassed by this request complies
with 5 CFR 1320.9 and the related provisions of 5 CFR
1320.8(b)(3).
The following is a summary of the topics, regarding
the proposed collection of information, that the certification
covers:
(i) Why the information is being collected;
(ii) Use of information;
(iii) Burden estimate;
(iv) Nature of response (voluntary, required for a
benefit, or mandatory);
(v) Nature and extent of confidentiality; and
(vi) Need to display currently valid OMB control
number;
If you are unable to certify compliance with any of
these provisions, identify the item by leaving the box unchecked
and explain the reason in the Supporting Statement.